Taking Into Operation; Maintenance/Servicing - Cooper Crouse-Hinds CEAG HLE 7 L EN Mode D'emploi

5. Taking into operation

Prior to taking the cap lamp into opera-
tion, check its correct functioning and
perfect condition in accordance with
these operating instructions and other
applicable regulations!
The cap lamp may be opened or charged
outside of hazardous areas only!
Initial use
Mind: For safety reasons, the battery is
delivered uncharged!
By means of the attached connecting lead,
the HLE 7 L EN cap lamp is connected to the
mains supply.
The switch of the lamp must be in "OFF"
position.
After apx. 18 h, the lamp will automatically
switch over to trickle charge.
The whole useful battery capacity will only be
obtained after the battery has been submit-
ted to at least 3 charging/discharging cycles.
For electrochemical reasons the battery's
charge cannot be ensured at temperatures
below -5°C.
At temperatures >30°C, a full charge of the
battery will not be possible for
electrochemical reasons.
Recommendation:
Prior to charging, the battery should be kept
so as to obtain room temperature (apx.
20°C).

6. Maintenance/Servicing

As far as the maintenance, servicing and
test of electrical apparatus for explosive
atmospheres are concerned, the respec-
tive national regulations in conjunction
with the relevant standards will be
applicable!
Mind: Because of the NiCd batteries' self-
discharge, these should be recharged every
4 to 6 months, even if the lamp has not been
used.
Lamp replacement
Lamp replacement may only be performed
in a non-hazardous area!
1. Switch off the lamp and pull the charging
plug out of the lamp.
2. Unscrew the hexagon socket head screw
on the headpiece.
3. Then remove the bezel ring by turning it
left (do not dismantle the gasket/glass/
reflector group).
4. Lift the bulb out of the holder.
5. Remove the ejecting spring and ejecting
ring from the old bulb and fit them onto the
new one in the same manner.
6. When fitting in the new bulb, take care that
the asymmetrical soldering point on the
bottom of the lamp cap points towards the
switch.
7. Put the glass/reflector/gasket assembly
over the bulb, screw down the bezel ring
and secure it with the hexagon socket
screw.
Mind: Check the tight fit of the hexagon
socket head screw.
Replacement of the battery insert
Replacement of the battery insert
may be performed in a non-
hazardous area only!
Caution: Do not squeeze leads!
1. Switch off the lamp and pull the charging
plug out of the lamp.
2. Unscrew the hexagon socket head screw
on the locking shackle of the battery
container cover and open the cover.
3. Remove the charging plug (unscrew two
screws) and remove the battery insert.
4. Fit in the new battery insert and close the
lamp in inverse order.
Mind:Check the tight fit of the hexagon
socket head screw.
5. Charge the lamp in accordance with point
5. Taking into operation.
Note: Observe the national regulations on
waste disposal, when disposing of the
batteries.
Subject to alteration or supplement of
the product series.
Cooper Crouse-Hinds GmbH
5 5 5 5 5