Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Tuneable white
Tuneable white makes it possible to set a light colour from six pre-defined light colours within the range of
2700K to 6000K allowing you to choose between warm white and daylight white depending on the time of
day or lighting requirement.
The light colour is set at 3500K (neutral white) at delivery. To set one of the other five light colours, proceed
as follows:
Press the button
until the control LED on the sensor flashes red (colour change mode). If the control LED
lights up green when the
After the control LED has blinked red, you can switch to the next light colour by pressing the
ton. The following light colours are available: 2700K, 3000K, 3500K, 4000K, 5000K and 6000K.
If you have not changed the light colour for a period of 60 seconds, the luminaire exits the colour change
mode und returns to the dimming mode, meaning that you can now dim the light with the
tons. If you do not want to wait 60 seconds after setting another light colour to dim the light, press the
button until the control LED at the sensor flashes green (dimming mode).
Permanent change of the preset light colour
You can switch to another light colour at any time, as described above. This remains your "new light colour"
as long as the luminaire is connected to a power supply and voltage is applied. If the luminaire is switched
off by the button (floor lamp) or with the remote control, or if the luminaire switches off via the motion
sensor, the luminaire remembers its last set light colour. If, however, you want to disconnect the mains plug,
use a switched socket, or if the luminaire does not receive any voltage for a short time (in this case a few
milliseconds), the luminaire will reactivate with the 3500K light colour as pre-programmed by us.
If your luminaire is switched on/off by means of a switched socket or a light switch (suspension luminaire),
the luminaire will always switch on at the pre-programmed light colour of 3500K. If you want to change this,
proceed as follows:
1. Set the desired light colour.
2. Press the following button combination using the remote control:
0000
button is pressed, press the
71
button again.
7
or
but-
and
but-
Publicité
Table des Matières
