TOBIAS GRAU XT-S Notice D'utilisation page 3

Functions description for Remote Control
The remote control is not essential for the operation of the luminaire!
The remote control serves primarily to adjust the factory settings that we have already programmed, or
connect those luminaires equipped with LIGHTDIM CONNECT to each other. A status query can also be car-
ried out using the remote control to determine in which mode the luminaire is set (see Status check).
The remote control is delivered with the luminaire but is not tuned in to one specific luminaire so that you
can operate other luminaires equipped with the Tobias Grau sensor with the same remote control.
In addition, the luminaires can be switched on/off, dimmed, or set to a different light colour using the re-
mote control (see Tuneable white).
Programming
The individual programming steps are described below.
The remote control should be pointed towards the sensor when pressing the buttons.
There is not set time limit for entering combinations, allowing you enough time to enter the key combination
without rushing.
Should you press the wrong button by mistake, you can stop the process by pressing the
tively you can also turn the luminaire off and begin the command again.
NOTE: After entering the key combination
This indicates that you are in the programming mode. With the
mode at any time.
Mode description and instructions for changing the mode
Factory settings of the sensor
The luminaire is supplied with the
following mode settings:
0000 the LED at the sensor will begin to flash orange.
Mode 1 OFF
Mode 2 ON
Mode 3 ON
Mode 4 ON
Mode 5 OFF
Mode 6 OFF
After-glow period 15 mins
3
button you can exit the programming
button; alterna-