Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Afterglow Period
(Set to 15 mins/900 seconds at delivery)
The Afterglow Period is the time between the last movement detected and the luminaire switching itself off..
The Afterglow Period can be set as desired from one minute to 30 minutes with the Movement Sensor
activated (Mode 2 ON). Experience shows that our factory setting of 900 seconds is optimal for a normal
use of space. We do not recommend using a value less than 300 seconds as this can cause the luminaire to
malfunction.
Set Afterglow Period:
Status Enquiry (Enquiry mode)
The status of settings can be queried by means of the remote control. By executing the following key
combinations you will NOT be brought into the programming mode.
The indicator LED at the sensor will light up either green or red.
MODE 1
LED red:
MODE 1 OFF - Individual office space is active
LED green: MODE 1 ON - Open plan office mode is active
MODE 2
LED green: MODE 2 ON - Movement sensor is active
LED red:
MODE 2 OFF - Movement sensor is inactive
MODE 3
LED green: MODE 3 ON - Constant light regulator is active
LED red:
MODE 3 OFF - Constant light regulator is inactive
MODE 4
LED green: MODE 4 ON - Auto ON is active
LED red:
MODE 4 OFF - Auto OFF is active
MODE 5
LED green: MODE 5 ON - Saved light value with switch Z is possible
LED red:
MODE 5 OFF - Saved light value is not possible
MODE 6 only with installed LIGHTDIM CONNECT
LED red:
MODE 6 OFF - Swarmfunction inactive
LED green: MODE 6 ON - Swarm function active
0000
21
300...1800s
Key Combination
6
1
2
3
4
5
6
Publicité
Table des Matières
