Transport; Disposal/Environmental Protection; Troubleshooting - Parkside PADM 1250 A1 Traduction Des Instructions D'origine

GB IE

Transport

Caution! Hot surface. There is
a risk of burns. Only transport
the machine when it has cooled
down completely.
• The machine can be relocated over a
short distance with two people. Relocat-
ing the device over a longer distance
generally has to take place with a trans-
port aid.
• To carry, grip the device by the four feet
or by the feed and discharge table.

Troubleshooting

Problem Possible cause
Overload protection has
responded
No mains power supply
Machine does
Main circuit breaker is
not start
tripped
On switch (9)/
Off switch (10) is broken
Defective motor
Planer blade blunt
Device stops
Too much chip removal
Planed surface Workpiece to be machined
too rough too wet
32
Disposal/environmental
protection
The device, accessories and packaging
should be properly recycled.
Electrical devices must not be dis-
posed of with domestic waste.
• Take the device to a recycling plant. The
plastic and metal parts used on your de-
vice can be properly sorted according to
materials and grades and effi ciently re-
cycled. Please contact our service centre
for more information.
• Disposal of your sent in defective devices
is carried out free of charge.
Remedy
Press the overload switch (8) (reset), then
press the On switch (9)
Check the socket, mains supply cable,
cord, mains plug; if necessary, have them
repaired by a qualifi ed electrician. Check
the main fuse.
Repair by Customer Care
Repair by Customer Care
Replace planer blades
Reduce chip removal
Dry the workpiece