Cleaning And Servicing; Cleaning; Maintenance; Storage - Parkside PADM 1250 A1 Traduction Des Instructions D'origine

Replacement blades are available
from our online shop (see "Spare
parts/Accessories").
Replacing the blades
1. Unscrew the four hexagon socket
screws (32).
2. Remove the guide (33).
3. Remove the planer blade (34) from the
blade shaft (36).
4. Insert a new planer blade, making sure
that the two adjusting screws (35) are seat-
ed in the rectangular recesses in the blade.
5. Put the guides (33) onto the blade.
6. Fasten the blade using the four hexa-
gon socket screws (32).
Aligning the blade
The blade may protrude over the blade
block by max. 1.1 mm. After alignment,
the blade must be level on the blade set-
ting block.
1. Place the blade setting block (17) on
the blade shaft.
2. Adjust the blade height by screwing/
unscrewing the two adjusting screws
(35).

Cleaning and servicing

Remove the mains plug before car-
rying out any adjustments, mainte-
nance or repair work.
Have any work on the device
that is not described in this
instruction manual performed by a
professional. Only use original
parts. Allow the device to cool off
before performing any mainte-
nance or cleaning. There is a dan-
ger of burns!
Always check the device before using it for
obvious defects such as loose, worn or dam-
aged parts, correct the positioning of screws
or other parts. Replace damaged parts.

Cleaning

Do not use any cleaning agents or
solvents. Chemical substances may
attack the plastic parts of the ma-
chine. Never clean the device under
running water.
• Thoroughly clean the machine after ev-
ery use. Remove chips, dust and work-
piece remnants with a vacuum cleaner if
necessary.
• Clean the ventilation openings and the
surface of the machine with a soft brush
or cloth.
• Try to clean resinous surfaces with a
damp, lukewarm cloth that has been
wrung out well. Make sure that no liquids
can get into the interior of the housing!
Alternatively, you can use a special
cleaner (resin solvent) or multispray.
Please take notice of the safety informa-
tion and instructions provided by the
manufacturer of the special cleaner/
multispray.

Maintenance

The device is maintenance free.

Storage

• Store the device in a dry and dustproof
location and out of reach of children.
• The mains cable can be wound onto the
holders (30) on the back of the appli-
ance for storage, see Fig.
GB IE
.
31