Safety Information For Surface Planers And Thicknessers; Safety Equipment - Parkside PADM 1250 A1 Traduction Des Instructions D'origine

GB IE
workshop unless otherwise indicated
in the operating instructions.
– Damaged switches must be replaced
at a customer service workshop.
– Do not use power tools if the switch
cannot be turned on and off.
• CAUTION!
– The use of other bits and other acces-
sories can result in a risk of personal
injury.
• Have your power tool be repai-
red by a qualifi ed electrician
– This power tool complies with the re-
levant safety regulations. Repairs may
only be performed by a qualifi ed
electrician, using original spare parts;
otherwise accidents involving the user
may result.
Service:
• Have your power tool repaired
only by qualifi ed specialists and
only with original spare parts.
This will ensure that the power tool re-
mains safe.
Safety information for
surface planers and
thicknessers
• Check that the machine is in a
fault-free condition before use.
• Only use well-sharpened and
well-maintained blades.
• Only use blades that are de-
signed for this machine.
• When working, completely cov-
er the planer blade with the
blade cover at the points where
you are not planing.
• Wear personal protective equip-
ment when working.
Wear hearing protection to reduce
the risk of becoming hard of hearing.
26
Wear respiratory protection to re-
duce the risk of inhaling harmful dust.
• Wear gloves when handling the
blade shaft and when working
with rough materials. This reduces
the risk of injury from sharp edges.
• Do not carry out the following
work as this may cause injury:
- Insertion work, i.e. any machining
that does not extend over the entire
length of the workpiece;
- Do not create indentations, tenons or
recesses with the device;
- Do not plane very bent wood where
there is not suffi cient contact with the
feed table.
• Secure a long workpiece from
tipping by using a roller table or
similar.
• Do not operate the machine
without protective equipment.
• Damaged or contaminated work-
pieces can present a risk. The
penetration of metal parts and
spattering pieces into the work-
piece can be very dangerous.
• If possible, only connect the device to a
power socket with a residual current de-
vice (RCD) with a rated residual current
no more than 30 mA.

Safety equipment

• Safety switch in the recess (13)
ensures that the collection container with
connection for external dust extraction
is fi tted, otherwise the device cannot be
started
• Anti-kickback claws (
reduce the risk of kickback
• Planer blade cover (
prevents you from being able to reach
into the (running) blade shaft
24)
C
25)
D