Residual Risks; Fixed Installation; Commissioning The Surface Planer; Mounting The Rip Fence - Parkside PADM 1250 A1 Traduction Des Instructions D'origine

Residual risks

There will always be residual risks even
if you operate this power tool according
to the instructions. The following hazards
may occur in connection with the type and
design of this power tool:
a) Cutting injuries
b) Hearing damage if suitable ear protec-
tion is not worn.
c) Lung damage if a suitable protective
mask is not worn.
Warning! During operation, this
power tool produces an electromag-
netic fi eld. Under certain circum-
stances, this fi eld may negatively
affect active or passive medical
implants. In order to reduce the
danger of serious or fatal injuries,
we recommend that individuals
who wear medical implants should
consult their doctor and the manu-
facturer of the implant before oper-
ating the machine.

Fixed installation

Caution! The machine may tip
if it is not secured. Risk of in-
jury!
Secure the machine to the workbench,
placing suitable screw clamps on the four
lugs provided (7).
Commissioning the
surface planer
To use the machine as a surface planer, the
following assembly work must be carried
out.

Mounting the rip fence

1. Using the Allen key (15), unscrew the
two hexagon socket screws (19) from
the device housing (11) as far as need-
ed to be able to attach the rip fence (1).
The recesses in the rip fence (1) must
be placed on the two hexagon socket
screws (19).
2. Re-tighten the hexagon socket screws
(19) to fasten the rip fence (1).
Dismantling is carried out in reverse order.
Attaching the crank
handle
Place the crank handle (3) on the holder
(20) on the device housing (11).
Mounting the chip
extractor
1. Loosen the small screw (22) on the left
and right latch (21).
2. If necessary, remove the collection con-
tainer with connection for external dust
extraction (16) from the discharge table
(14).
3. Set the planing table (23) to the lowest
position with the crank handle (3).
4. Slide the collection container with con-
nection for external dust extraction (16)
under the discharge table (14).
5. Insert the two latches (21) into the re-
cesses (13) on the right and left of the
discharge table (14).
If the latches are not inserted correctly,
the machine will not start.
6. Fix the two latches by screwing in the
small screws (22).
7. Attach an external chip extractor to the
collection container (16).
GB IE
27