Cycle Options; Delay Start - GE DCVH480EK Manuel D'utilisation Et D'installation

About cycle options.
NOTE: Not all features are available on all dryer models.
8
Extend Tumble
Minimizes wrinkles by adding
approximately 20 minutes of constant
no-heat tumbling followed by 70 minutes
of intermittent no-heat tumbling after
clothes are dry. The dryer is in EXTENDED
TUMBLE when the ESTIMATED CYCLE TIME
display is illuminated in a circular pattern.
Damp Alert
This option causes the dryer to beep when
clothes have dried to a damp level. Remove
items that you wish to hang dry. The
DAMP ALERT will only beep when this option
is selected (dry cycle keeps running).
Removing clothes and hanging them when
they are damp can reduce the need to iron
some items.

Delay Start

Use to delay the start of your dryer.
1. Choose your dry cycle and any options.
2. Press the DELAY START button. You
can change the delay time in 1-hour
increments (up to 18 hours) each time
you press the DELAY START button. Stop
pressing the button when your desired
time is displayed.
3. Press the START/PAUSE button to start
the countdown.
The countdown time will be shown in the
ESTIMATED TIME REMAINING display.
The light in the button will light up when
EXTEND TUMBLE is on.
NOTE: It is normal for the drum to pause
for short periods of time during EXTEND
TUMBLE.
The light in the button will light up when
DAMP ALERT is on.
NOTE: Only for DRY, MORE DRY and EXTRA
DRY sensor dry selections.
NOTES:
If the door is opened while the dryer is in
DELAY, the countdown time will continue
to count down the delay time. If the door
is not closed and the countdown time
expires, the cycle will not start until the
door is closed and the START/PAUSE
button is pressed.
You can delay the start of a dryer cycle
up to 18 hours.
The light in the button will light up when
DELAY START is on.