Cycle Options; Drum Light; Delay Start - GE Profile DPVH880 Manuel D'utilisation Et D'installation

About cycle options.
NOTE: Not all features are available on all dryer models.
Press to lock control.
Hold 3 seconds to unlock.
Extend Tumble
Minimizes wrinkles by adding approximately
60 minutes of no-heat tumbling after clothes
are dry.
Damp Alert
This option causes the dryer to beep when
clothes have dried to a damp level. Remove
items that you wish to hang dry. The DAMP
ALERT will only beep when this option is
selected.

Drum Light

Press this button to turn on the light in the
dryer.
Press the button again to turn the light off.
This only controls the light when the door
is shut. NOTE: The light will turn off by itself
after one minute when the door is shut.
When the door is opened, the light comes
on automatically.

Delay Start

Use to delay the start of your dryer.
1. Choose your dry cycle and any options.
2. Press DELAY START. You can change the
delay time in 1/2 hour increments, using
the L or M arrow pads.
3. Press the START/PAUSE button to start
the countdown.
The countdown time will be shown in the
ESTIMATED TIME REMAINING display.
Lock
You can lock the controls to prevent any
selections from being made. Or you can lock
the controls after you have started a cycle.
Children cannot accidentally start the dryer
by touching pads with this option selected.
GEAppliances.com
The light around the button will light up when
EXTEND TUMBLE is on.
Removing clothes and hanging them when
they are damp can reduce the need to iron
some items.
The light around the button will light up when
DAMP ALERT is on.
The light around the button will light up when
DRUM LIGHT is on.
NOTES:
I If the door is opened while the dryer is
in DELAY, the countdown time will not
restart unless the door is closed and
START/PAUSE button has been pressed
again.
I You can delay the start of a dry cycle up
to 24 hours.
The light around the button will light up when
DELAY START is on.
To lock the dryer, press the LOCK button. To
unlock the dryer, press and hold the LOCK
button for 3 seconds.
The light around the LOCK button will light up
when the controls are locked.
Even though the controls are locked, the
POWER button is still active in case you have
to turn the unit off.
9