Using Instructions - Trebs Comfortheat 99360 Mode D'emploi

USING INSTRUCTIONS

IMPORTANT: allow several minutes for the pad to preheat. If there is a red blinking "HIgh" light, this
means an error has occurred. Unplug the pad from the outlet and inspect the condition of the cord and
the function of your main outlet. If blinking continues, stop using the pad and contact the Trebs customer
service.
Press OFF when stop using.
Plug the heat and massage pad into a 220V-240V outlet.
Place the pad on your body as shown on the picture so it will fit your body
perfectly and fasten it with the clip closure.
Turn on the switch of the controller's backside and then select the desired
heat or massage function on the front of the controller. IMPORTANT: if the
heat indicators do not light up or stay on, unplug from the electrical outlet.
To apply heat, turn on the switch at the controller's backside, then press the
heat activation button and select your desired temperature: HI, MED or LOW
Press Low for low heat
Press Med for med heat
Press Hi for high heat
To activate the massage feature, turn on the switch at the controller's
backside, then press the massage activation button to select your desired
speed:
Press 1x - low pulse - Press 4x - med steady
Press 2x - low steady - Press 5x - hi pulse
Press 3x - med pulse - Press 6x - hi steady
The auto-off feature is included in the control on the heating pad. The auto-
off allows to conserve energy by turning off after 2 continuous hours of use.
The massage feature will automatically shut off after 15 minutes of use.
IMPORTANT: the auto-off timer will reset after a power outage.
11