Remote Control - Conrad RW12MP Notice D'emploi

b) Remote control
• If the remote control no longer works, the battery needs to be replaced.
• The battery CR2025 is placed in a small insert that is at the bottom of the remote control.
• First, turn the remote control around so that the buttons point down.
• Push the small lever ("PUSH" at the top of the figure) towards the middle and at the same time
pull the insert ("OPEN" at the top of the figure) out.
• Remove the old battery and insert a new battery CR2025 into the insert. Observe the proper
polarity (plus/+ and minus/-). If the insert is placed as in the image above, the plus pole of the
battery must point up.
• Slide the insert back into the remote control until it latches.
• The battery change in the remote control is now completed.
67