Commissioning Of The Camera; Inserting The Batteries - Conrad RW12MP Notice D'emploi

8. Commissioning of the camera

• To perform the following items, you first need to open the lock (B6) of the camera and fold
open the lid.
• When you are done with insertion of the batteries and the memory card, as well as with con-
figuration, close the lower camera lid and lock it again (B6).
☞
Before you start, check if the camera is off. If this is not the case, move the switch
(B4) to the position "OFF".
a) Inserting the batteries
• Now pull out the battery compartment by the metal bracket (B7).
• Insert 8 AA batteries in the compartment. Observe the proper polarity (plus/+ and minus/-). In
the battery compartment, the direction in which you have to insert the batteries is marked.
• Now push the battery holder into the camera again in the right direction until it is latched
completely. Then fold the metal bracket over again.
☞
Even with the camera off, it may consume a small amount in the μA-range. There-
fore, we recommend removing the battery if you are not using the camera.
For this, it is sufficient to pull the entire battery chute out a little.
51