Installation Of Accessories - Hkoenig NV60 Manuel D'utilisation

3. About 4 minutes after power suppl y is turned on, steam is ready. At this time lightly press
the steam button and check whether steam is sprayed out of the nozzle. (Do not aim the spray
nozzle at other Persans or abjects).
4. If there is steam sprayed out, please install suitable accessories according to your needs
after you release the button.
5. Press down the steam button a gain in order to carry out the operations required by you.

INSTALLATION OF ACCESSORIES

1. Install the long spray cup
Hold the pipe section of the long spray cup in your hand, align the arrow on the spray cup
with the single-line mark on short spray nozzle on the machine body, and insert the spray cup
in position. Rotate the spray cup in clockwise direction, and align the arrow on the spray cup
with the double-line mark on short spray nozzle on the machine body, as shown in:
Figure 1. Fix the spray cup on the machine body. To remove the long spray cup, please rota te
the spray cup inversely (counterclockwise) as shown in Figure 2, and align the arrow on the spray
cup with the single-line mark on the machine body. Then the long spray cup can be pulled out.
2. Install spray cup with round brush or bent spray cup
For direct installation on short spray nozzle, aim the spray cup with round brush or bent spray
cup at the top of spray nozzle, as shown in Figure 3, and push the spray cup upwards until it is
in position. As the short spray nozzle and spray cup are positioned in six directions, the angle
and direction can be adjusted during the installation. Or, first install long spray cup and then the
spray cup with round brush or bent spray cup.The spray cup with round brush or bent spray
cup and long spray cup can be installed in the same procedures as the installation on short
spray nozzle.
3. Installation of spray cup for door/window