Quick Reference; Attaching The Stand; Quick Installation Tips - Sharp LC-55LE643U Mode D'emploi

QUICK REFERENCE

Attaching the Stand

• Before attaching (or detaching) the stand, unplug the AC cord.
• Before performing work spread cushioning over the base area to lay the TV on. This will prevent it from
being damaged.
CAUTION
• Be sure to follow the instructions. Incorrect installation of the stand may result in the TV falling over.
1
Confirm that there are 4 screws supplied with the stand unit.
2
Put the TV face down on a safe surface that is covered by a soft and smooth cloth.
3
Attach the TV stand to the bottom of the TV.
4
Fasten the 4 screws by using a crosshead screwdriver.
CAUTION
• Do not push too hard or put excessive pressure to the stand neck to avoid damage to the TV.
• Do not remove the stand from the TV unless using an optional wall mount bracket to mount it.
• After attaching the stand to the TV, do not hold the stand when you put up, set up, move or lay down the
TV.
NOTE
• To detach the stand, perform the steps in reverse order.

QUICK INSTALLATION TIPS

1
Attach your antenna to the back of the television. (See page 6.)
2
Connect the AC plug for the television into the AC outlet.
• Place the TV close to the AC outlet, and keep the power plug within reach.
NOTE
• TO PREVENT RISK OF ELECTRIC SHOCK, DO NOT TOUCH UN-INSULATED PARTS OF ANY CABLES
WITH THE AC CORD CONNECTED.
3
When turning on the TV for the first time, press POWER on the TV.
POWER
4
Insert the batteries into the remote control unit. (See page 6.)
NOTE
• Speakers cannot be detached from the TV.
• The TV angle cannot be adjusted.
AC IN
5