Appendix - Sharp LC-55LE643U Mode D'emploi

Appendix

Wall Mount Kit Specifications
Standard dimensions for wall mount kits are shown below.
• The illustration is based on the LC-55LE643U model as an example.
a1
a2
AC IN
A
SCREW
WALL MOUNT
UNIT
CABINET
DEPTH OF
MOUNTING
MOUNTING HOLES
HOLES
For the screws, refer to the table shown below.
Model
Item LC-55LE643U
Screw Dimensions M6 x 10mm x 12.0mm
Quantity 4pcs
NOTE
• Do not mount the TV at a tilt.
• To use this TV mounted on a wall, remove the cable tie as needed.
• Do not use screws that do not comply with the VESA standard screw specifications.
• Do not use screws that are longer than the standard length. Screws that are too long may cause damage to the inside of the TV.
• Do not fasten the screws too firmly or loosely. This may damage the product or cause the product to fall, leading to personal injury. SHARP is not liable for these kinds of accidents.
• SHARP is not liable for product damage or personal injury when a non-VESA or non-specified wall mount is used or the consumer fails to follow the product installation instructions.
28
WALL
Item
Wallmount Footprint
WALL MOUNT KIT
v The mounting means should be strong enough to bear the weight of the display.
v The wall mounting bracket should have UL or related approval.
COMPONENT / VIDEO DTV / TV
1 2 Y/V Pb/Cb Pr/Cr L AUDIO R CABLE / ANTENNA
c1
WALL MOUNT KIT
LC-65LE643U
M6 x 10mm x 12.0mm
4pcs
Model
LC-55LE643U LC-65LE643U
400mm x 400mm 400mm x 400mm
Do not install the wall mount kit while your TV is turned on. It may result in personal injury due
to electric shock.