Starmix NSG Série Notice D'utilisation page 15

– Set auxiliary air slide on the handle tube
Suck up liquids
Volume of liquid
Small volume of liquid
Large volume of liquid
1. Remove filter bag from the dirt container before sucking up liquids.
2. Slightly open auxiliary air slide on the handle.
3. Move switch to position I.
Before switching off the vacuum cleaner:
1. Remove suction nozzle from the liquid.
9 Residual water in the suction hose is sucked into the container and cannot leak out.
If the floating valve disrupts the suction process when the container is full:
1. Switch vacuum cleaner off.
2. Empty dirt container and filter cartridge.
Connect an electrical tool
See Fig. C.
Use socket on vacuum cleaners with automatic switch on/off (switch position A) to connect electrical tools. The
vacuum cleaner is switched on and off by the electrical tool. In switch position 0, the socket can be used as an
extension cable, e.g. for a light.
Connection value: Vacuum cleaner + electrical tool = max. 16 A (value depends on the country version, pay
attention to technical data).
WARNING!
The socket on the vacuum cleaner is always live.
Risk of injury due to electrical tool automatically starting up.
1. Before plugging in: Switch off electrical tool.
Smart Stop
See Fig. D.
Apply brake to prevent the vacuum cleaner from rolling away.
Blowing function
See Fig. E.
Only use the blowing function for cleaning, removing dust from and drying machines and appliances.
After work
See Fig. F.
1. Roll up mains connection cable and suction hose.
2. Store the accessories in the accessories holder.
Tools required
Main filter (filter cartridge)
Water nozzle
Main filter (foam)
Water nozzle
en
15