Replacing The Lamp; Closing The Door - Zanussi ZBA30455SA Notice D'utilisation

Problem
The compressor does not start
immediately after pressing the
QuickFreeze, or after changing
the temperature.
Water flows into the refrigera-
tor.
Door is misaligned or interferes
with ventilation grill.
The temperature in the appli-
ance is too low/too high.

Replacing the lamp

The appliance is equipped with a longlife LED
interior light.
Only service is allowed to replace the lighting
device. Contact your Service Center .
24
Possible cause
Food products are not wrap-
ped properly.
Temperature is set incorrectly.
This is normal, no error has oc-
curred.
The water outlet is clogged.
Food products prevent that
water flows into the water col-
lector.
The appliance is not levelled.
The temperature regulator is
not set correctly.
The door is not closed correct-
ly.
The food products' tempera-
ture is too high.
Many food products are stored
at the same time.
The thickness of the frost is
greater than 4-5 mm.
The door has been opened of-
ten.
The QuickFreeze function is
switched on.

Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
"Installation".
3. If necessary, replace the defective door
gaskets. Contact the Service Center.
Solution
Wrap the food products bet-
ter.
Refer to "Operation" chapter.
The compressor starts after a
period of time.
Clean the water outlet.
Make sure that food products
do not touch the rear plate.
Refer to "Levelling".
Set a higher/lower tempera-
ture.
Refer to "Closing the door".
Let the food products temper-
ature decrease to room tem-
perature before storage.
Store less food products at the
same time.
Defrost the appliance.
Open the door only if necessa-
ry.
Refer to "QuickFreeze func-
tion".
www.zanussi.com