Brewing Drinks - Philips 4300 Série Mode D'emploi

Assembling LatteGo (specific types only)
Assembling the classic milk frother (specific types only)
2

Brewing drinks

General steps
1 Fill the water tank with tap water and fill the bean hopper with beans.
2 Insert the small plug into the socket located on the back of the machine. Insert the mains plug into
the wall socket.
3 Press the on/off button to switch on the machine.
-
The machine starts heating up and performs the automatic rinsing cycle.
-
When all lights in the drink icons light up continuously, the machine is ready for use.
4 Place a cup under the coffee dispensing spout. Slide the coffee dispensing spout up or down to
adjust its height to the size of the cup or glass you are using (Fig. 2).
Brewing coffee with beans
1 To brew a coffee, tap the drink icon of your choice (Fig. 3) or tap the 'More Drinks' icon (Fig. 4)
(specific types only).
-
You can now adjust the drink to your personal taste (Fig. 5). Use the up and down arrows (Fig. 6)
to adjust the coffee strength. Tap the OK icon if you want to adjust more settings (Fig. 7).
2 Press the start/stop
3 To stop dispensing coffee before the machine is finished, press the start/stop
To brew 2 coffees at the same time, tap the drink icon twice or select the 2x icon scrolling the
dedicated bar.
Do not use caramelized or flavored coffee beans.
Brewing milk-based drinks with LatteGo (milk container)
LatteGo consists of a milk container, a frame and a storage lid. To avoid leakage, make sure the
frame and the milk container are properly assembled before you fill the milk container.
CLICK
1
button at any time to start brewing the selected drink.
English
11
button again.