Publicité
Les langues disponibles
Les langues disponibles
Declaration of conformity.
Hereby, Hesdo declares that the radio equipment type Alecto AK-
30 is in compliance with directive 2014/53/EU. The full text of the
EU declaration of conformity is available at the following internet
address: http://DOC.hesdo.com/AK-30-DOC.pdf
Installation.
Open the battery compartment at the rear of the clock by
depressing the tab of the battery cover and then sliding the cover
forwards. Insert 3 x 1.5V size AAA batteries (MICRO-LR03). The
use of Alkaline batteries is recommended. While installing the
batteries, pay attention to the correct polarity as indicated inside the
battery compartment. Finally, close the battery cover and place the
clock on a flat surface.
Automatic time settings.
The clock now immediately starts searching for the DCF radio
signal. Depending on the strength of the signal, this may take
anywhere from 5 minutes to several hours.
User tips:
•
The clock loses all its information when the batteries are
removed.
•
Don't expose the clock to direct sunlight, heat, coldness, high
humidity or wet environments.
•
Only clean the clock with a moist cloth. Don't use any cleaning
agents.
-25-
Publicité
