GB
VisionAire
™
III. CLEANING
III. 1. Cleaning
Only the outside of the VisionAire
is to be cleaned, with a dry cloth or, if necessary, a damp
™
sponge and clean or soapy water, then thoroughly dried. Acetone, solvents or any other flammable
products must not be used. Do not use abrasive powders.
III. 2. Everyday disinfection
Due to the presence of the product filter inside the device, everyday disinfection only concerns the
external oxygen therapy accessories: humidifier, nasal cannulas (refer to the respective instructions
for use).
The following minimum guidelines must be respected:
• Humidifier:
Daily:
- empty the water from the humidifier.
- rinse the humidifier flask under running water.
- Fill the humidifier up to the mark with water.
Regularly:
- Disinfect the equipment by immersing them in a disinfectant solution (in general, we recommend
using water containing a small amount of chlorine bleach).
- Rinse and dry.
- Check that the humidifier lid seal is in good condition.
• Oxygen administration devices:
Follow the manufacturer's instructions.
AirSep
Corporation
®
4-GB
MN137-1 Rev B. 11/09