Stocking The Beverage Center - KitchenAid KUBR204ESB00 Guide D'utilisation Et D'entretien

3. Replace the shelf by inserting the back edge of the shelf
against the rear support in the back of the compartment.
4. Align the front of the shelf to the ledge on the front of the
shelf support.
5. Gently place the shelf into place.
Remove and Replace the Wine Racks
NOTE: When storing large bottles or magnums, remove the
rack directly above.
1. Pull the rack forward until it stops.
2. Lift up on the left-hand lever while pressing down on the
right-hand lever to release the rack. Pull the rack forward
and lift it up and out of the rack supports.
3. Replace the rack by inserting the rack into the supports
and sliding it toward the rear of the beverage center.
8
A
A. Lever

Stocking the Beverage Center

NOTES:
For optimum wine storage, place white wines on the upper
rack of the beverage center and place red wines on the lower
rack of the beverage center.
The wine racks can be stocked with the bottles facing either
direction, however, to optimize storage adjacent bottles
should be facing in opposite directions.
To Stock the Beverage Center:
1. Starting on the left-hand side of the bottom rack, place the
first bottle with the neck of the bottle facing the front of the
beverage center.
2. Place the next bottle on the rack with the neck of the bottle
facing the back of the beverage center. Alternate the direction
of the bottles, in this manner, until the display rack is full.
3. Slide the bottom rack into place and pull the next rack
forward. Stock the remaining rack as described In the
previous steps.
4. Place juices, sodas or other canned beverages on the
glass shelves.