Cleaning, Maintenance And Ordering Of Spare Parts - EINHELL RT-VC 1500 Mode D'emploi

Anleitung_RT_VC_1500_SPK1:_
Crevice nozzle (Fig. 1/21)
The crevice nozzle (21) is designed for vacuuming
solids and liquids in corners, edges and other areas
that are difficult to access.
Upholstery nozzle (Fig. 1/22)
For cleaning upholstery use the upholstery nozzle
(22).
5.5 Automatic cable rewind (Fig. 10/18)
The wet and dry vacuum cleaner is fitted with an
automatic cable rewind (18).
Before using:
Pull the power cable out of the vacuum cleaner
slowly and evenly.
After using:
With one hand actuate the pushbutton of the
automatic cable rewind (18), with the other hand
guide the power cable while it is being pulled into the
appliance by the automatic cable rewind.
5.6 Storage compartment (Fig. 11/19)
The wet and dry vacuum cleaner is fitted with an
storage compartment (19) for accessory equipment.
Swing the storage compartment (19) towards the
front to open.
5.7 Accessory holder (Fig. 11/12)
The wet and dry cleaner is equipped with a holder for
the space-saving storage of vacuum nozzles.
5.8 Vacuum tube holder (Fig. 12/6)
Insert the vacuum tube into the vacuum tube holder
(6) as shown in the illustration.
6. Operation
6.1 ON/OFF switch (Fig. 1/2)
Switch position 0:
Switch position I:
6.2 Dry vacuuming
For dry-vacuuming, use the pleated filter (15). In
addition, you can also fit the dirt bag. (see point 5.2)
Always ensure that the filters are perfectly secure.
6.3 Wet vacuuming
For wet-vacuuming, use the foam filter (16) (see point
5.2).
Check that the filter is securely fitted at all times.
21.08.2007 16:35 Uhr
Important!
When wet vacuuming, the floating safety switch (5)
turns off the wet and dry vacuum cleaner
automatically when the maximum level is reached.
Important!
The wet and dry vacuum cleaner is not suitable for
the vacuuming of combustible liquids.
For wet vacuuming, use only the supplied foam filter.
6.4 Blowing
Connect the suction hose (11) to the blow connector
(10) on the wet and dry vacuum cleaner.
7. Cleaning, maintenance and ordering
of spare parts
Important!
Always pull out the mains power plug before starting
any cleaning work.
7.1 Cleaning
b Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible.
b We recommend that you clean the appliance
immediately after you use it.
7.2 Cleaning the appliance head (3)
Clean the appliance regularly with a damp cloth and
some soft soap. Do not use cleaning agents or
solvents; these may be aggressive to the plastic parts
in the appliance.
7.3 Cleaning the container (8)
The container can be cleaned with a damp cloth and
some soft soap or under running water, depending on
the amount of dirt.
7.4 Cleaning the filters
Off
Cleaning the pleated filter (15)
On
Clean the pleated filter (15) regularly by carefully
patting it and cleaning it with a fine brush or hand
brush.
Cleaning the foam filter (16)
Clean the foam filter (16) with a little soft soap under
running water and allow it to air-dry.
7.5 Maintenance
At regular intervals and before each use, check that
the filters in the wet and dry vacuum cleaner are
securely fitted.
Seite 11
GB
11