Dell PowerEdge 4210 Guide D'installation page 27

You can route cables out of the rack in two ways on a standard configuration:
• Through the space at the bottom of the rear doors (see Figure 1-11)
• Upward through the four rack ceiling holes and into a cable raceway (see
Figure 1-11)
NOTICE:
To protect cables from abrasion, ensure that the plastic grommets are
installed in the rack ceiling holes before routing cables to a cable raceway.
Some systems may require additional space, for instance those that use high-
density cables. For systems that require additional space for routine cables a
separate door kit may be purchased to provide a third routing option:
NOTE:
An optional door kit may be purchased through a special order from Dell.
Look for ordering information included in your system's packaging.
• Through the space at the top of the doors created by removing the door
panels (see "Optional Door Kit With Removable Panels" on page 25)
Figure 1-12. Optional Door Kit With Removable Panels
1
1 captive screws
Dell™ PowerEdge™ 4210 Installation Guide
25