Use; Preparation - Imetec L6801 Mode D'emploi

PREPARATION

• Remove the charging base (2), the handpiece (1) and the plug
(9) from the packaging.
• Fully charge the battery before using the appliance for the first time.
CHARGING THE BATTERY
• Insert the handpiece (1) into the charging base (2) (fig. A)
• Insert the plug output connector (9A) in the charging connection (2B).
• Insert the plug (9C) into an electrical outlet: the operating and
charging LED (1B) will begin to flash to indicate that the appliance
is charging.
• The appliance is fully charged and ready for use when the
operating and charging LED (1B) remains on. This operation
can take up to 3 hours.
• Disconnect the plug output connector (9A) from the charging
connection (2B): the operating and charging LED (1B) will go off.
• When the battery must be recharged, a timer emits 3 beeps every
30 seconds to indicate that the appliance is about to switch off.
The appliance has a capacity of about 90 minutes at intensity 1 and
about 60 minutes at intensity 2.
Never cover the appliance and the plug while charging!
ATTENTION! For an ideal battery life, it is recommended
to charge it regularly, and in any case at least every
6 months.
NOTE: Do not use the appliance while it is charging.
ASSEMBLY
Before use, fit the pre-set head (3,4,5,6,7) on the handpiece coupling
area (1A), taking care to match the attachment areas (fig. B).

USE

EN
39