oventrop Regudis W-HTF Notice D'utilisation page 18

Installation
Illust. 4: Height marking
3. Position the flush-mounted cabinet at the designat-
ed installation location.
4. Fix the cabinet at the feet and the wall attachment
points. Depending on the model, you have to attach
the flush-mounted cabinet at different points (see
QR code 3.1 on page 16; the QR code refers
to the design description of the flush-mounted
cabinets - the wall attachment points are marked in
blue).
5. Fit the dwelling station and its accessories into
the flush-mounted cabinet. Observe the operating
instructions of the different components. Please
observe the installation sequence when fitting the
components.
2 3 4
1
Illust. 5: Fixing points of the Regudis W-HTU
(1) Nut M6
(2) Washer
(3)
Suspension point of the base plate of the dwell-
ing station
(4) Threaded pin
(5) Rubber washer (25 x 12 x 8 mm)
(6)
Fixing point for the dwelling station in the
flush-mounted cabinet (rivet nut)
18
5 6
2
3
1
Illust. 6: Fixing points of the Regudis W-HTF
(1)
Nut M6
(2) Washer
(3) Suspension point of the base plate of the dwell-
ing station
(4)
Rubber washer (20 x 6 x 2 mm)
(5) Fixing point for the dwelling station in the
flush-mounted cabinet (threaded pin)
6. Refit the door of the flush-mounted cabinet.
You can use the cardboard for the protection of
the door during the construction phase.
The surface heating distributor/collector is
installed from the right to the left (see Illust. 7
on page 19).
Flush-mounted cabinet
4 5
134117580-V01.09.2020