Enerpac AVBOLT Manuel D'instructions page 43

Putting Into Service
• MOTOR – This screen displays the number of hours or On/Off cycles the motor has been operated. Toggle between
Hours and Cycles by pressing the Down or Up Arrow buttons. The counter is non-resettable. Save the setting and
step forward using the MENU button.
• LOW VOLT – This screen displays the low voltage hour-meter (non-resetable). "LOW VOLT" is defined as an
operating condition with the main power supply at or below 80% of nominal voltage. This screen allows the operator
to read the number of hours the pump has been operated in a low voltage condition. Step forward by pressing the
MENU button.
•
ADVANCE – This screen displays the number of hours (On/Off cycles) the Advance solenoid has been operated. This
is the placing tool pull cycle. Toggle between HOURS and CYCLES by pressing either the Down or Up Arrow
buttons. Step forward by pressing the MENU button.
SCREEN 6
MOTOR
4.8
HOURS CYCLES
SCREEN 7
LOW VOLT
0
HOURS CYCLES
SCREEN 8
ADVANCE
188
HOURS CYCLES
15