Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Safety Instructions
This instruction manual must be read with particular attention to the following safety rules, by any person
installing or operating this pump.
1.
Do not use outside the design intent.
2.
Do not use equipment with this pump other than that recommended by Avdel UK Limited.
3.
Any modification undertaken by the customer to the pump shall be the customer's entire responsibility.
4.
Always fully disconnect the pump from the power supply before attempting any work.
5.
The pump should always be positioned on a flat stable surface
6.
Ear and eye protection must be worn by the operator and those in the vicinity. Noise levels for this equipment
exceed the permitted maximum. For these values see pages 7 to 9 of this manual and the installation tool
manuals.
7.
Do not fit flexible hoses rated at less than 700 bar (10,000 psi) working pressure.
8.
Avoid damaging hydraulic hoses. Avoid sharp bends and kinks when routing hydraulic hoses. Using a bent or
kinked hose will cause severe back-pressure. Sharp bends and kinks will internally damage the hose leading to
premature hose failure.
9.
Do not drop heavy objects on hoses. A sharp impact may cause internal damage to hose wire strands and lead
to premature hose failure.
10. Do not lift, pull or move the hydraulic pump unit using the hoses. Always use the pump unit handle or roll cage.
11. The normal operating pressure shall not exceed 550 bar (8,000 psi). Never set the relief valve to a higher
pressure than the maximum rated pressure of the pump. Higher settings may result in equipment damage
and/or personal injury.
12. The system operating pressure must not exceed the pressure rating of the lowest rated component in the
system.
13. The pump should be kept clean and dry for safe and easy operation.
14. Keep hydraulic equipment away from flames and heat. Excessive heat will soften seals, resulting in fluid leaks.
Heat also weakens hose materials. For optimum performance do not expose equipment to temperatures of 150
°F (65 °C) or higher. Protect hoses from weld spatter.
15. Do not handle pressurized hoses. Escaping oil under pressure can penetrate the skin, causing serious injury. If
oil is injected under the skin, see a doctor immediately.
16. Do not use electric pumps in an explosive atmosphere. Adhere to all local and national electrical codes. A
qualified electrician must do installation and modification.
17. These pumps have internal factory adjusted relief valves, which must not be repaired or adjusted except by an
Authorized Avdel
18. To prevent damage to pump motor, check specifications. Use of incorrect power source will damage the motor.
19. The machine must be maintained in a safe working condition at all times and examined at regular intervals for
damage and function by trained competent personnel. Any dismantling procedure shall be undertaken only by
personnel trained in Avdel
maintenance instructions. Contact Avdel
20. The machine shall at all times be operated in accordance with relevant Health & Safety legislation. In the UK
the "Health & Safety at Work etc Act 1974" applies. Any question regarding the correct operation of the
machine must be directed to Avdel
4
®
Service Centre.
®
procedures. Do not dismantle the machine without prior reference to the
®
with your training requirements.
®
.
Publicité
Chapitres
Table des Matières
