Phottix Odin TTL Mode D'emploi page 9

compatible cameras specifi ed shutter speed to be
used. Shutter speeds up to 1/8000 sec. can be
achieved with compatible cameras and fl ashes.
2. Note: At high shutter speeds the power of fl ashes
is greatly reduced.
3. SCS will fi re the fl ash at the end of an exposure, not
at the beginning. This can be combined with longer
exposures for creative eff ects.
The Phottix Odin Receiver
Setting Groups on the receiver
1. The Phottix Odin receiver has three group settings.
2. Move the Group Selection Switch to A, B or C to select
a group for each receiver.
Setting Channels on the receiver
1. The Phottix Odin receiver has 4 channels.
2. Move the Channel Selector Switch to 1, 2, 3, or 4 to
select a channel.
3. Ensure the Phottix Odin TCU and receivers are set to
the same channel.
8
En
Connecting a fl ash to the Odin receiver
hot shoe
1. Turn off the fl ash and the Phottix Odin Receiver.
2. Slide the fl ash into the receiver's hot shoe mount.
3. Lock the fl ash with the fl ash's locking mechanism.
4. Turn on the fl ash and the Phottix Odin receiver.
Connecting the Odin receiver by cable
1. Turn off the fl ash/strobe and the Phottix Odin receiver.
2. Connect a cable to the receiver's 3.5 mm PC Sync Port.
3. Connect the opposite end of the cable to a fl ash or
studio strobe (A 6.3 mm adapter is included for
studio strobes with larger ports).
4. Turn on the fl ash/strobe and the Phottix Odin receiver.
Set the fl ash to Manual mode – no TTL functions can
be used when a compatible fl ash is triggered by cable.
INSTRUCTION MANUAL