Using Zoom - Phottix Odin TTL Mode D'emploi

Adjusting fl ash zoom
The Phottix Odin allows the zoom level of fl ashes to be
set wirelessly. Zoom can be set as TTL or Manual. When
TTL is selected: The fl ash zoom setting will change
dynamically as a camera zoom ring is adjusted. In
Manual mode, the fl ash zoom can be changed to the
desired zoom setting.

Using Zoom

1. Press the Zoom Button to enter the Zoom screen
2. Pressing the Selection button will cycle through
groups A, B and C, and Transmission channel.
3. Note: Pressing the Selection button after the CH
selection will return to the TTL/Mixed or Ratios
Function Screens.
4. With groups A, B or C active: Press the Mode Button
to change from TTL to Manual mode. In Manual
Zoom, press the - / + buttons to adjust the fl ash
zoom. No adjustments can be made in TTL mode.
Using the Clear Button
1. The Clear Button will erase any setting currently in the
TCU.
2. Press the Clear button to remove TT/M/Off , Ratio,
Zoom and EV settings currently in the TCU.
3. The transmission channel set on the TCU will not be
reset and stay on the channel selected by the user
after the Clear Button is pressed.
Using the Test Button
The test button will fi re all fl ashes connected to Phottix
Odin receivers that are on the same channel as the TCU.
1. Press the Test button.
2. Flashes will fi re in sequence: Group A, followed by
Groups B and C.
Using High Speed Sync (HSS) and
Second Curtain Sync (SCS)
Pressing the HSS/SCS button will cycle between HSS,
SCS and standard operations.
1. HSS will allow shutter speeds longer than a
7