Motor Fixing; Wire Connection - SCS Sentinel intensive1A Safety kit Manuel D'installation Et D'utilisation

C

MOTOR FIXING

Assemble the rear bracket and fix it on the pillar.
20
Release the gate opener and place the pin into the fitting position no.1 and no. 2.
Make sure the gate openers are mounted in horizontal position especially in those positions.
1) Gate in "CLOSE" position
2) Gate in "OPEN" position
3) Gate at "45。angle" position
Prior to weld the bracket on the gate leaf(if necessary), cover the gate opener to prevent
damages from sparks.
To place your bracket on the gate, with a battery, fully deploy your cylinder and tuck it a centimeter.
D

WIRE CONNECTION:

White(+)
1
Yellow(-)
2
Red(5V)
3
Green(Signal)
4
Black(GND)
5
no.1
A
B
Motor
Motor
Hall Sensor
Hall Sensor
Hall Sensor
no.2
1
2
3
4
5
3