Initial Use; Setting The Device - Beurer medical FT 70 Mode D'emploi

4. Initial use

The batteries are already inserted in all new devices. Before first use, remove the protruding plastic insulating strip from the
battery compartment. The thermometer will then switch on automatically.

5. Setting the device

Set the language, volume, the unit in which the temperature will be displayed, the date and the time
8 8 8
88:88
When the thermometer is used for the first time and each time the batteries are changed, the date and time are displayed in
the format during the basic set-up (after the self test). Set each of the following settings in turn: language, volume,
unit in which the temperature will be displayed, date and time. To set the device, proceed in stages: Language (L01 – Ger-
man, L02 – English, L03 – French, L04 – Italian, L05 – Russian, L06 – Turkish), Volume (U01 – lowest setting, U06 – highest
setting), Unit – year – month – day – hours – minutes (there is no voice output when setting date and time).
• Press the button for approx. three seconds in order to reach Set mode.
The setting to be changed will flash each time.
• Press the button again to save the setting or
• press the button to change the setting.
• Then press the button to save the setting.
After this process, the thermometer shows the word
Turning volume on and off again
Turn the device on and the speaker symbol [15] shows whether the voice function is on or off. Press the Set button
to turn the voice function on and off. When you turn the voice function on, a short beep sounds (speaker symbol visible =
voice function on; speaker symbol not visible = voice function off).
22
Press the button for 1 second to switch the thermometer on. The device performs a
brief self test: all elements of the display are shown for approx. 1 second. Following a
successful self test, the device emits two short beeps. In Standby mode, the date and
8
time are shown and " " is displayed.
in the display and switches off automatically.