Montiss CVC638 Mode D'emploi page 31

CLEANING AND CHARGING THE VACUUM CLEANER
A. How to empty out dust and clean
the dust cup
1. Remove the dust cup from the body.
2. Press the release button on the
bottom of the dust cup, the dust will
fall out automatically. Usually you
only need to operate as shown in
(Fig. A).
3. If the turbine system is too dirty,
press the dust cup release button,
take out the filter assembly out of
the dust cup, and clean them with a
soft brush or wash them with water.
You should dry them completely
before you use again (Fig. B).
B. Changing or cleaning the sponge
and filter
1. Remove the dust cup from body.
2. Rotate the
anticlockwise
"open", take out the dust cup cover.
Remove the sponge and filter set.
(Fig. A)
3. After removing the sponge and filter
from the ventilation cover, clean the
sponge and filter using a soft brush
or rinse it in lukewarm water and dry
them completely before use again.
All the filters are washable (we
recommend cleaning the filters
when the suction power feels weak.)
(Fig. B)
Note: Ensure that all the above filters are
installed in the correct places before
operating the vacuum machine.
dust cup cover
from "close" to
Push
Push
Dust Cup Bottom Re
Dust Cup Bottom
lease Button
Release Button
Filter System
Plastic Centering
Filter System
Fig. A
Fig. B
Sponge and
Sponge and
HEPA Filter
Filter
Fig. A
Fig. B
31