Care And Maintenance; Troubleshooting; Corrective Action - ClassicFlame 34HF601GRA Manuel D'instruction

CARE AND MAINTENANCE

CLEARANCE TO COMBUSTIBLES
Keep electrical cords, drapery, furniture and other combustibles at least 3 ft. from the front of the heater
and away from the sides.
CLEANING TRIM
Clean the metal trim using a soft cloth, slightly dampened with a citrus oil-based product and buff with a
clean soft cloth. Do not use brass polish or household cleaners as these products will damage the metal
trim. Citrus oil-based products can be obtained at supermarkets or hardware stores.
WARNING: Make sure the power is turned off before proceeding. Any electrical repairs
or rewiring of this unit should be carried out by a licensed electrician in accordance with
national and local codes.
If repairing or replacing any electrical component or wiring, the original wire routing,
color coding and securing locations must be followed.
WARNING: Electrical outlet wiring must comply with local building codes and other
applicable regulations to reduce the risk of fire, electrical shock and injury to persons.
WARNING: Do not use this fireplace if any part of it has been under water. Immediately
call a qualified service technician to inspect the fireplace and replace any part of the
electrical system.
WARNING: Disconnect power before attempting any maintenance or cleaning to reduce
the risk of fire, electrical shock or personal injury.
WARNING: During any service of this appliance, the power to the unit must be turned off.
First turn the main power switch to the OFF position. Then remove the electrical plug from
the wall outlet.

TROUBLESHOOTING

PROBLEM
No power.
Main power switch is in "ON"
position, but no flame effect.
Have flame effect, but
heater does not blow warm air.
Heater doesn't work, but
power and heater switches
are in the "ON" position.
POSSIBLE CAUSE
Power cord was not
plugged in the outlet.
Spinner motor doesn't
work.
Heater or blower
doesn't work.
The product is on the
protected status.
13

CORRECTIVE ACTION

Check that unit is plugged into a standard
120V outlet.
Open the front panel and place in a safe
position, and check if the spinner motor
was working.
Try to turn on/off heater button several times
to make sure it is at "ON" position, and the
indicator light should light up at the same
time.
Turn all switches to the "OFF" position and
unplug the unit from the wall outlet for 5
minutes. After 5 minutes plug the unit back
into wall outlet, and operate as normal.