Wet Cleaning - SPARKY Professional VC 1650MS Notice Originale

Check the dust bag regularly and replace it when it is 2/3
full. The bag is designed in such way that only air, and no
dust, can pass through the paper. Therefore a used dust
bag shall not be reused.
NOTE: Do not use the dust bag for vacuuming up objects
with sharp edges or wet objects.
WARNING: Never use a dust bag for wet
cleaning.
AUTOMATIC MODE WITH POWER TOOLS
▪ Make sure that the appliance is not plugged into the
power mains.
▪ Open the clamps and remove the upper section.
▪ Check to make sure that the tank (19) is free of dust
and dirt.
▪ Place a pleated polyester filter (5), appropriate for the
intended operation, on the filter basket and screw the
cap on the filter basket. Place back the upper section
on the tank and close the clamps (Fig.25).

WET CLEANING

WARNING: Never vacuum hazardous materi-
als.
▪ Make sure that the appliance is not plugged into the
power mains (Fig.27). Check to make sure that the
tank (19) is free of dust and dirt.
▪ Remove the dust bag (15) or the pleated polyester fil-
ter if you have used it before and fit the foam filter (17)
over the filter basket (Fig.28).
▪ Place the upper section onto the tank and clip it
(Fig.29).
▪ Fit the hose larger end on the front air intake stub on
the tank.
▪ Select the appropriate nozzle or tube and slide it over
the suction tube (Fig.30).
▪ Make sure that the appliance ON/OFF switch (12) is in
the "OFF" position "O" before you plug the power plug
6
EN
▪ Set the ON/OFF switch of the power tool you intend to
operate to the "OFF" position "O".
▪ Connect the vacuum cleaner adapter (9) to the dust
extraction of the power tool (Fig.26).
▪ Plug the power tool into the built-in socket (11) of the
vacuum cleaner.
▪ Insert the vacuum cleaner plug into the mains supply
socket.
▪ Set the vacuum cleaner switch (12) to the "ON" posi-
tion "I".
▪ Set the automatic mode switch (10) into position "=".
▪ Switch on the power tool.
The vacuum cleaner will switch on automatically as soon
as you switch on the power tool. When you switch off the
power tool, the vacuum cleaner will also switch off after
a pre-set delay.
EU
RU
B
into the socket.
▪ Insert the plug into the socket. (Fig.31)
▪ To switch the motor place switch (12) to position "I"
(Fig.32). Place the automatic mode switch (10) to po-
sition "–" (Fig. 33).
▪ When you have finished wet vacuuming, switch the
motor off by putting the ON/OFF switch (12) into the
„OFF" position "O".
▪ Unplug the vacuum cleaner.
▪ After use, empty and dry the tank (Fig.34).
Tip: If you want to vacuum a large quantity of liquid from
a sink or a tank, please don't put the entire suction nozzle
in the liquid; rather leave a little space so that some air
can also be drawn in along with the liquid.
The appliance is equipped with a float switch (14) that will
stop the vacuuming when the tank is full. You will notice
that suction has stopped by the motor now running fast-
er. In this event, switch the cleaner off, unplug it, remove
the upper section from the tank and empty the liquid into
A (Voltage) B (Power input)
230 V 2200 W
220V 2200 W
A
VC 1650MS