Noise/Vibration Information; Explanation Of Figures - Bosch Indego M 700 Notice Originale

Robotic Lawnmower
Input voltage (AC)
Protection class
Frequency
Output voltage (DC)
Protection type
Weight
A) Depends on cutting height, grass conditions and moisture
B) Internal battery temperature

Noise/Vibration Information

Noise emission values determined according to
EN 50636-2-107.
Typically the A-weighted noise levels of the product are:
Sound power level 61 dB(A). Uncertainty K = 2 dB.

Explanation of Figures

Action
Accessories
Delivery scope/unpacking the mower B
Laying out perimeter wire
Extending perimeter wire
Laying perimeter wire around new in-
ner object
Lifting up and carrying the mower
Setting the height of cut
SpotMow
Cleaning
Maintenance
Adding a further lawn area
– with additional docking station
(right)
– without additional docking station
(top left)
Replacing the battery
Software update
Power supply unit connection
Installation
For a video guide on how to install the mower, please visit
www.bosch-indego.com or use the following QR-Code. Al-
ternatively, follow the Installation Guide delivered with the
product.
Bosch Power Tools
SI
Unit
V
Hz
V
kg
Figure Page
Remove stones, loose pieces of wood, wire, live mains
A 423
cables and other foreign objects from the cutting area.
424
Make sure that the cutting area is even and has no ditches,
grooves and steep slopes above 15°/27 %, which are clear
C 424
obstructions for the mower.
D 425
The docking station must be positioned on the wire at an
E 425
outer edge of the cutting area. It may not be positioned on
the side of a tool or garden shed standing as an island within
F 426 the lawn to be mowed.
It is recommended that you mow your lawn once with a con-
G 426
ventional lawnmower before installing and before the first
H 427
mowing of the new season and whenever the grass clippings
I 428
would be longer than 5 mm.
J 428 The mower's cutting system is designed to cut small lengths
of grass (30–50 mm). The clippings can remain as mulch to
K 427
fertilize the lawn. The height of cut for mower can be adjus-
ted to 30, 40 and 50 mm.
It is recommended to start with a higher setting and then
gradually decrease the height of cut as the wire disappears
under the grass. This prevents your Indego from cutting the
L 429
wire.
Additional perimeter wire can be added using a wire con-
M 430−431
nector (see figures D–E).
N 432
The perimeter wire can be extended up to a maximum length
of 350 m.
The perimeter wire can be buried up to 5 cm under the
ground (or under non-metallic slabs).
To avoid causing damage to the perimeter wire, do not verti-
cut or rake the area where it is positioned.
When laying out the wire avoid angles of less than 45°. This
can affect the performance.
Indego M 700
220-240
/ II
50–60
24
IPX7
1.25
Check if the perimeter wire is fully pegged to
the ground avoiding any slack lengths of wire.
Any loose wire can be a trip hazard.
F 016 L81 885 | (23.10.2019)
English | 25
Indego M+ 700
220-240
/ II
50–60
24
IPX7
1.25