Onkyo CS-N575D Mode D'emploi page 24

> Before Start > Part Names
Using RDS (CS-N575D)
RDS stands for Radio Data System and is a method of
transmitting data in FM radio signals. In regions using
RDS, the radio station name is displayed when you
tune into a radio station broadcasting program
information. When you press
controller in this state, you can use the following
functions.
Displaying text information (Radio Text)
1. While the name of the station is being displayed on
the display, press (c) on the remote controller
once.
Radio Text (RT) broadcast by the station is displayed
scrolling across the display. "Not RDS" is displayed
when no text information is available.
0 Unusual characters may be displayed when the unit
receives unsupported characters. However, this is
not a malfunction. Also, if the signal from a station is
weak, information may not be displayed.
Search for stations by Program Type
1. While the name of the station is being displayed on
the display, press (c) on the remote controller
twice.
2. Press the PRESET 2/1 (g) on the remote controller
to select the Program Type you want to find, then
press ENTER (h) to start the search.
The Program Types displayed are as follows:
None
News (News reports)
Current affairs
Information
Sport
Education
Drama
24
> Install
Cultures
Science (Science and technology)
Varied speech
Pop music
Rock music
Easy listening
(c) on the remote
Light classics m
Serious classics
Other music
Weather & Metr
Finance
Children's progs (Children's programmes)
Social affairs
Religion
Phone in
Travel & touring
Leisure & hobby
Jazz music
Country music
Nation music
Oldies music
Folk music
Documentary
0 The information displayed may sometimes not
match the content being broadcast by the station.
3. "FINISH" is displayed when a station is found and
the frequency display flashes. Press ENTER (h)
while this is happening to start receiving that station.
If you don't press ENTER (h), the unit continues to
search for another station.
0 If no stations are found, the message "Not Found" is
displayed.
0 Unusual characters may be displayed when the unit
receives unsupported characters. However, this is
not a malfunction. Also, if the signal from a station is
weak, information may not be displayed.
> Initial Setup > Playback
Supplementary information | Advanced Setup | Others