Connect The Speakers; Before Installing - Onkyo CS-N575D Mode D'emploi

> Before Start > Part Names

Connect the Speakers

Install
1
a
a
a
3
RED
a Non-Skid Pads, b Speaker Cable
10
> Install
2
a
RED
b
b
> Initial Setup > Playback
4
RED
Supplementary information | Advanced Setup | Others

Before Installing

Attach the included non-skid pads to the four corners of
the bases of the front speakers. This makes the
speakers less likely to slip, improve the stability of the
installation, and enables better sound.
Instructions on how to connect speakers
Connect the included speaker cables with ends with
the red tubing attached to the i jacks on the main unit
and the speaker. If connection is wrong, the phase
reverses and this makes it harder to output bass. After
inserting the speaker cables, tighten the terminals
firmly by turning to the right. Also make sure the
exposed wires of the speaker cables do not stick out of
the speaker terminals when connecting. If the exposed
wires of the speaker cables touch the rear panel or the
i and s wires touch each other, the protection circuit
may be activated and the power may turn off.