Package Contents; Using The Included Floor Pads For Speakers; Using The Remote Controller; Replacing The Battery - Onkyo CS-265DAB Manuel D'instructions

Package Contents

Make sure you have the following items:
CD Receiver (CR-265DAB)
Remote controller (RC-892S)
indoor DAB/FM antenna
Power cord
(Plug type varies from country to country.)
Speakers (D-T25)
Speaker cables
8 floor pads
* In catalogs and on packaging, the letter at the end of
the product name indicates the color. Specifications
and operation are the same regardless of color.
Using the Included Floor Pads for
speakers
You can improve the sound quality by attaching the
included floor pads to raise the speakers off the surface
and reduce the contact area. The floor pads also make
the speakers stable and prevent them from slipping.

Using the Remote Controller

Remove the insulation sheet before using the remote
controller.
When using the remote controller, point it toward the
CD receiver's remote control sensor, as shown below.
Remote control sensor
6
En-
Installation Location
This unit and its remote controller might become
discolored by ultraviolet or other light components if
you use them in direct sunlight, or under fluorescent
lighting or germicidal lamp.

Replacing the Battery

Use only a battery of the same type (CR2025).
While pressing a tab on the back of the
remote controller in the direction of the
arrow, pull out the battery holder.
Back side
Floor pads
Bottom
Note:
• If the remote controller doesn't work reliably, try
• If you intend not to use the remote controller for a
• Expired batteries should be removed as soon as
• If the remote controller does not operate when it is
CR-265DAB
Caution:
• Replacing the battery incorrectly may cause an
Battery holder
replacing the batteries.
long time, remove the batteries to prevent damage
from leakage or corrosion.
possible to prevent damage from leakage or
corrosion.
used for the first time, try performing the following
operations.
1. Hold down the remote controller's VOLUME [–]
button (for at least ten seconds). If the remote
controller still does not operate, repeat this
operation.
2. Remove the button battery, wipe it with a dry
cloth, and then insert it again.
explosion. Use only a battery of the same type or an
equivalent.
Place the battery in
the battery holder with
the positive (+) side
facing up, and then
insert the battery
holder into the remote
controller.