Keypad; Dialing Keys; Light Emitting Diodes (Leds) - Fluke Networks TS 30 Guide De L'utilisateur

The TONE/PULSE switch is on the inside of the hand
grip near the receiver. This switch selects the dialing
mode.
Figure 2. Controls and Indicators

Keypad

See Figure 3.
The TS30 Test Set keypad includes 12 standard dialing
keys and 4 special purpose keys. All keys on the keypad
are functional when the unit is in the Talk mode. They
are not functional when the unit is in the Monitor
mode.
Figure 3. Keypad
MUTE: Pressing the MUTE key shuts off the TS30
transmitter for as long as the key remains depressed.
POLAR: When an off-hook unit is connected to a
powered telephone line, pressing the POLAR key
causes one of the LEDs to turn on. The LEDs indicate
the polarity of direct current on the telephone line.
FLASH: Pressing the FLASH key will cause a timed
interruption of the loop current. Some PBX setups or
telephone office switches may use this signal to put a
call on hold or to activate some special function.
REDIAL: This key allows the user to redial the last
number dialed.

Dialing Keys

See Figure 3.
When the TONE/PULSE switch is in the TONE position,
each of the 12 dialing keys, when pressed, generate
dialing tones. This includes the asterisk (
bfl02.eps
pound (#) keys. When the TONE/PULSE switch is in the
PULSE position, only the numeric keys (1, 2, 3, 4, 5, 6, 7,
8, 9, 0) will cause pulses to be generated when pressed.
In Pulse mode, the asterisk and pound keys are not
functional. In Pulse mode the asterisk and pound keys
will not be stored in the redial memory.
The special purpose keys are labeled MUTE, POLAR,
FLASH, and REDIAL.

Light Emitting Diodes (LEDs)

See Figure 3.
The LEDs are on each side of the keypad. One or the
other of the LEDs will light only when the test set is in
the Talk mode, connected to a powered telephone
line, and the POLAR key is pressed. The LEDs indicate
the polarity of current on the transmission line. See
"Polarity Check".
bfl03.eps
Physical Characteristics
∗
) and the
3