Operating The Tea/Coffee Maker; Automatic Shut-Off - Proficook PC-TKS 1056 Mode D'emploi

5. Only connect the machine to a properly installed
safety socket.
6. Set the switch on the water kettle to the "I" posi-
tion. The indicator lamp on the handle will light
up.
Pausing/terminating operation
There are two options to interrupt the boiling pro-
cess or to terminate it:
• The appliance will shut off automatically after
the boiling process. The indicator lamp will go
out.
• Set the switch to the "0" position to pause or
terminate the boiling process.
WARNING: Danger of scalding!
• When pouring the water out, keep the lid
closed.
• During operation the housing becomes hot. Do
not touch it and allow the device to cool down
before storing it away.
CAUTION:
• Do not remove the appliance from the base
without shutting it off first.
• Also ensure that it is shut off before setting it
back onto the base.
• Disconnect the power cord.
• Emptying the water container.

Operating the tea/coffee maker

1. Use the water kettle to boil water as described in
chapter "Operating the water kettle".
2. Remove the filter. Measure the tea or coffee as
desired and add to the filter.

NOTE:
• You may also put tea bags into the filter.
• Use medium or coarse ground coffee.
3. Replace the filter in the tea/coffee maker. Make
sure the square notch in the attachment is
aligned with the handle.
4. Take the water kettle from the base and carefully
pour the hot water into the tea/coffee maker.
48
Only fill up to the maximum mark (-- 8 --). Check
the water level indication on the appliance for
the current water level.
5. Tea: Leave the tea as indicated to steep and
then enjoy.
Coffee: Wait 1-2 minutes and then enjoy your
coffee.
Hotplate
You may keep the brewed tea/coffee warm by
switching on the hotplate underneath the tea/coffee
maker.

NOTE:
The buttons on the base station are touch but-
tons. Slightly touch the buttons with a finger to
select the function.
• Press the button to turn on the hotplate. The
pilot lamp TEA will light up. The display shows
the temperature preset by the factory of 80 °C.
• You can use the MOD button to select the
warm-keeping temperatures preset by the fac-
tory for tea (80 °C) or for coffee (85 °C). The
respective pilot lamp will light up.
• You may use the and buttons to manually
set the temperature for the hotplate. The control
range is between 70 °C and 90 °C.
CAUTION: Danger of scalding!
The hotplate heats continuously, even if the tea/
coffee maker is not on the plate. Always switch off
the hotplate if the tea/coffee maker is not on the
plate or if the tea/coffee maker is empty.

Automatic shut-off

The hotplate will shut-off automatically after
60 minutes, if no entry was performed on the
control panel within that time. The notification in the
display will go out. This circuit serves your safety.
Stop operation
• Make sure that the hotplate is shut-off.
• Then disconnect the mains cable from the wall
socket.