Reliaguard Installation Rights And Wrongs - Watts Dormont ReliaGuard Instructions D'installation Et D'utilisation

ReliaGuard Installation Rights and Wrongs

WARNING
!
Upon completion, the ReliaGuard gas connector MUST NOT BE kinked, twisted, or torqued,
and the end fi tting of the connector MUST NOT BE subjected to sharp bends . The addition of
one or two Dormont SwivelGuard multi-plane swivels can assist in eliminating sharp bends and
kinks in your installation . Refer to the following "Rights and Wrongs" to assist in your installation .
ReliaGuard Gas Connector
Installation
RIGHTS & WRONGS
SHARP BENDS: Install ReliaGuard gas
connector for vertical traverse with a single,
natural loop . Avoid sharp bends that strain
and twist the connector to a point of early
failure at the coupling .
Always install the ReliaGuard gas connec-
tor such that the end fittings are parallel
(never perpendicular) to both the wall and
appliance .
TWISTING: Couplings and gas connector
should be installed in the same vertical
plane . Failure to do so causes torsional
twisting and undue strain, which will cause
premature failure .
FATIGUE: Maintain the minimum or larger
bending diameter between the couplings
creates double bends causing work fatigue
at the fittings .
RESTRAINING CABLE: Install the
restraining cable so that the connector is
not kinked when the restraining cable is
fully extended .
WRONG
Avoid sharp bends
and kinks when
pulling equipment
away from the wall.
Maximum pull will
kink ends, even if
installed properly, and
reduce connector life.
WRONG
CM
GAS
FLOW
GAS
FLOW
WRONG
DORMONT
SnapFast
WRONG
DORMONT
SnapFast
WRONG
DORMONT
SnapFast
RIGHT
Minimum pull of
equipment away from
the wall is permissible
for accessibility to the
QD (where installed).
RIGHT
DORMONT
SnapFast
RIGHT
DORMONT
SnapFast
RIGHT
DORMONT
SnapFast
RIGHT
DORMONT
SnapFast
9