Hach Lachat BD40 Manuel D'utilisation page 14

Figure 9 Time to temperature
1 Setpoint temperature (°C)
Temperature
change (°C)
0–25
25–200
200–325
325–425
Edit a method
Do this procedure to change the temperature profile of a method already programmed into the
controller.
1. On the Menu tab, select the method. The Run tab opens.
2. Select the Edit tab.
3. Select the options to edit.
4. Push the method name to edit the name if necessary.
Use the international keyboard
To use special characters in a method name, use the international keyboard function.
1. Select the Edit tab.
Note: To enter a name for a new method, refer to
2. Push the method name.
3. On the keypad, push INTL. The international keyboard shows.
4. To make an international character, refer to
5. To go to the standard keyboard, push INTL.
14 English
Table 3 Temperature increase rates (°C/minute)
25–50
1
— 20 minutes
—
—
2 Time to temperature (minutes)
Set point temperature (°C)
50–225 225–350
3
—
—
Program a new method on page 12.
Table 4.
350+
2 2
4 3
8 4
— 5