Velleman CU2200 Notice D'emploi page 14

• A/D Parameters Setup
Command: PWD:XXXX,ADVALE1:XXXXX,NNNNN,Y,ZZZZZ,WWWWW%
1 Channel 1
XXXXX Measuring range
NNNNN Start value
Y 1: triggered alarm enabled
0: triggered alarm disabled
ZZZZZ Threshold high value setup
WWWWW Threshold low value setup
• A/D Channel Alarm Setup
Command: PWD:XXXX,ADCOUTB:YY,ZZZZ,NNN%
XXXX Password
B 0 (please refer to command 10 – low voltage alert)
1: A/D channel 1
2: A/D channel 2
YY 00 means alarm not reported to control centre
10 means alarm reported to control centre 1
01 means alarm reported to control centre 2
11 means alarm reported to control centre 1 and 2
ZZZZ Selection of the alarm phone dial and alarm SMS
0 means no alarm report
1 means SMS only
2 means phone dial only
3 means SMS first, then phone dial
ZZZZ
4
3
rd
2
nd
1 phone number
st
NNN Relay output control
0 means no relay output control
1 means relay output triggered by alarm
NNN
3
rd
2
nd
1 relay output
st
• System Parameters Report
Command: PWD:XXXX,PARAMETER2%
About the A/D channel
[SMS message received]
ST:XXX;VL:XXXXX,O:AX,BBBB,CCC:A1M:XXXXX,XXXXX,R,WWWWW,WWWWW,O:AX,BBBB,CCC;A2M:X
XXXX,XXXXX,R,WWWWW,WWWWW,O:AX,BBBB,CCC;K1:A,O:AX,BBBB,CCC;#
CU2200_v4
phone number
th
phone number
phone number
relay output (not available)
relay output (not available)
14 VELLEMAN