Velleman CU2200 Notice D'emploi page 10

Masquer les pouces Voir aussi pour CU2200:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

• SMS Message Contents
Command 8 is used to program the alarm message contents. The CU2200 will reply to the mobile phone with
the programmed message for that alarm channel.
Command: PWD:XXXX,READYTEXT%
XXXX
Password
Y
Alarm channel number (1 ~ 8)
• Commanding the CU2200 to Send SMS Message
This command is used to make the CU2200 to send the SMS message for testing purposes.
Command: PWD:XXXX,SENDMSA:B%
XXXX
Password
A
Phone number (1 ~ 4)
B
SMS message selection
0: schedule health check content
1~8: alarm channel SMS message content
9: manual input message content
Example:
PWD:1234,SENDMS4:9,GoodMorning%
Password
SMS message "Good Morning" will be sent to phone number 4.
Reply message: Success!: CU2200 succeeds in sending message.
• Relay Output Control
Command: PWD:XXXX,COUTN:Y%
Password
N
Y
The relay output is N.O. by default.
Command COUTN:1 is not valid when the relay output is triggered by alarm. Reply message will be ST:XXX in
this case.
In the above case, command COUTN:0 is used to reset the relay output after the alarm is triggered.
• Relay Output Delay Time
Command: PWD:XXXX,OUTNDLAY:YYYY%
XXXX
Password
N
Relay output channel (1 ~ 3) (outputs 2 and 3 not available)
YYYY
0000 – 9999 seconds
0000 Turn the output on or off (default)
0005 Turn on the output for 5 seconds and off again
The relay output delay time is good for controlling e.g. an electric door lock.
CU2200_v4
1234
Default! NONB: no preset phone number, operation failed.
Default!: Operation failed but phone number exists.
1234
Relay output channel (1 ~ 3) (outputs 2 and 3 not available)
1
0
Turn off the output for 5 seconds and on again
Turn on (close) the output
Turn off (open) the output
10
VELLEMAN

Publicité

Table des Matières
loading

Table des Matières