Button Functions - VDO OceanLink-7 Notice D'utilisation

On/Off
The on/off mode depends on the connection made during installation.
The VDO logo and software version followed by a security message appear when turned on followed by
the last data page viewed before turned off.
Page Calibration wizard
Page Calibration wizard appears when first turned on after reset and every time turned on until
sensors are calibrated.
The display prompts you to configure sensors. Choose Yes, to open menu SENSOR CONFIG. Choose
No, to display the first default data page and sensors can be configured later.

Button functions

Button Function
Briefly press:
Open the menu
l
Return to the previous menu
l
Hold down:
From any point to return to the data pages
l
Briefly press:
Scroll pages/options
l
Pressed simultaneously:
Set the display and connected 52 mm gauges brightness
l
Briefly press:
Open a sub-menu
l
Confirm the selection
l
Hold down:
In the MediaBox page to save the selected station radio frequency
l
Briefly press:
View the data page linked to the button
l
Hold down:
Link the button to the displayed data page
l
Configure the display
Following are the steps for initial configuration:
1. Connect any sensors to analog inputs.
2. When turned on, read the security message, then selectYes to open the menu SENSOR CONFIG
and configure sensors (see "Sensor configuration" on page 64).
3. Set up general device operations (see "System settings" on page 57).
4. Add/remove data pages selecting the best layout and data to be viewed (see "Data page
configuration" on page 53).
7" TFT display | Operating instruction v. 1.0 | © 2018 Continental Automotive Switzerland AG
Getting started
49