Accessories - Makita BFR540 Manuel D'instruction

1
2
008285
Use a screwdriver to remove two screws then remove
the front cover.
008287
Raise the arm part of the spring and then place it in the
recessed part of the housing with a slotted bit
screwdriver of slender shaft or the like.
006816
Use pliers to remove the carbon brush caps of the
carbon brushes. Take out the worn carbon brushes,
insert the new ones and replace the carbon brush caps
in reverse.
006817
Make sure that the carbon brush caps have fit into the
holes in brush holders securely.
1. Casing
2. Thumb screw
1. Front cover
2. Screws
1
2
1
1. Spring
2. Arm
3. Recessed part
3
2
1. Carbon brush
cap
1
1
2
006304
Reinstall the front cover and tighten two screws
securely.
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.

ACCESSORIES

CAUTION:
These accessories
•
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons.
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
Drywall screw strip
•
Phillips bit
•
Various type of Makita genuine batteries and
•
chargers
Plastic carrying case
•
8
1. Hole
2. Carbon brush
cap
or attachments
Only use accessory or
are