, CH+/–, +/–, and TV buttons
The
cannot be located on the TV.
See below illustration for location of the buttons
on the TV.
Rear of TV
The illumination LED is turned on.
If you do not wish to light up the illumination LED,
you can turn it off.
Press HOME, then select [Settings] t
[Illumination LED] t [Off].
Cannot connect to a wireless router by WPS
(Wi-Fi Protected Setup).
If you use WEP security, select [Easy] t [Wi-Fi] t
[Connect by scan list]. Then, select the network
name (SSID) you want to connect.
Cannot find the required network name in
network setup.
Select [[Manual entry]] and press
network name.
Specifications
System
Panel system
LCD (Liquid Crystal Display) Panel, LED Backlight
TV system
Depending on your country/area selection
Analogue: B/G, D/K, L, I
Digital: DVB-T/DVB-C
Satellite: DVB-S/DVB-S2
Colour/video system
Analogue: PAL, SECAM, NTSC3.58 (Video only),
NTSC4.43 (Video only)
Digital: Refer to the Help Guide.
Channel coverage
Analogue: UHF/VHF/Cable, Depending on your
country/area selection.
Digital: UHF/VHF/Cable, Depending on your
country/area selection.
Satellite: IF Frequency 950-2,150 MHz
Sound output
7.5 W + 7.5 W + 7.5 W + 7.5 W
Wireless technology
Protocol IEEE802.11ac/a/b/g/n
(IEEE802.11ac may not be available depending on
countries/regions.)
Bluetooth Version 4.1
Input/Output jacks
Antenna (aerial) cable
75 ohm external terminal for VHF/UHF
Satellite antenna
Female F-Type Connector IEC169-24, 75 ohm.
DiSEqC 1.0, LNB 13 V/18 V & 22 kHz tone, Single
Cable Distribution EN50494.
to enter
/
21-pin scart connector (CENELEC standard)
including audio/video input, RGB input and TV
audio/video output.
/
YP
P
B
1080i (50, 60 Hz), 720p (50, 60 Hz), 576p, 576i,
480p, 480i
Audio input (phono jacks)
AV2
t
Video input (common phono pin with Y input)
DVB-T2
AV1
COMPONENT IN
(Component Video): 1080p (50, 60 Hz),
R
GB
27
GB