sunjoe SJGC7 Instructions D'origine page 4

Assembly
Your garden + utility cart requires assembly. Account for all
parts and hardware before beginning assembly. If any parts
are missing or damaged, or if you have any questions or need
additional instructions, Please call the Snow Joe
customer service center at 1-866-SNOWJOE
(1-866-766-9563).
NOTE: When assembling your cart, place the heads of all
screws to the inside and hex nuts with flat washers to the
outside.
NOTE: The wheels may be sent in an under-inflated condition.
Use a standard bicycle pump to inflate as needed.
Tools needed:
• Wrench (included)
• Screwdriver (not included)
1. Lay the front angle clamp down (flat) on floor and stand
the bottom panel on the front angle clamp. Align the three
holes in the bottom panel with the three holes in the front
angle clamp (Fig. 1).
Fig. 1
2. Push three M6 x 25 screws through the bottom panel
and the front angle clamp. Secure the screws with
#2 flat washers and hex nuts, and tighten (Fig. 2).
Fig. 2
Hex nut
Flat washer #2
+ Sun Joe
®
Bottom panel
Front angle clamp
Flat washer #2
M6 x 25
screws
3. Turn the front angle clamp and bottom panel upside
down, and lay the side angle clamps on the bottom panel
(Fig. 3).
Fig. 3
®
Side angle
clamp
4. Secure the axle clamps to the side angle clamps and the
bottom panel by using four M6 x 30 screws, lock washers,
#2 flat washers and hex nuts. Do not tighten until the axle
is fully assembled (Fig. 4).
Fig. 4
Hex nuts
Lock
washers
Axle clamp
Axle clamp
Flat washer #2
5. Secure the side angle clamps and bottom panel together
with four M6 x 25 screws, eight #2 flat washers, and four
hex nuts. Tighten the four nuts (Fig. 5).
Fig. 5
Hex nut
Flat
washer #2
4
Bottom
panel
Lock
washers
Hex nuts
Hex nut
Flat
washer #2
M6 x 25
screws
Front angle
clamp
Side angle
clamp
M6 x 30
screws