sunjoe SJGC7 Instructions D'origine page 5

6. Stand the cart on end with the front angle clamp down on
the floor. Temporarily place the four #1 flat washers on the
inside of the front angle clamp (Fig. 6).
Fig. 6
7. Lay the front panel down onto the front angle clamp, on
top of the four #1 flat washers (Fig. 7).
Fig. 7
NOTE: The washers are used here as shims (spacers) and not
for assembly. They will be removed and used for wheel and
axle assembly.
8. Position a side panel against a side angle clamp, resting
on top of the front panel (Fig. 8).
Fig. 8
Side angle
clamp
Side panel
Flat washers #1
Front panel
Bottom
panel
Front panel
9. Secure a supporting strap on the side angle clamp and
the front angle clamp by two M6 x 25 screws, four #2 flat
washers, and 2 hex nuts (Fig. 9).
Fig. 9
Side panel
Side angle
clamp
Flat
washers #2
Hex nuts
10. Secure the side panel with the side angle clamp by a
M6 x 25 screw, two #2 flat washers, and a hex nut (Fig. 10).
Fig. 10
Hex nut
Side angle
clamp
Side
panel
11. Secure the side panel with the front angle clamp by a
M6 x 25 screw, two #2 flat washers, and a hex nut
(Fig. 11).
5
Flat
washers #2
Front angle
M6 x 25
clamp
screw
Supporting
strap
M6 x 25
Bottom
screw
panel
Flat
washer #2
Front
panel
Front
panel